Hello！We are Office restoration Dot.Com. website.
We are doing decorative finishing construction work professionally of 『Interior decorative work』『Restoration work』and the like, mainly at Ikebukuro area, Tokyo, and also in all over Kanto area, for you.
In winter season, it is getting awfully dry, isn’t it?
In winter, please be cautious of fire! Understanding cause of fire outbreak and countermeasures.
Every year when winter comes, we often hear nationwide news of fire disasters reported by the press.
The other day, a fire broke out in our neighborhood area. As we were concerned about renovation and reform after fire, we checked it.
We should be careful of fire outbreak throughout the whole year. However, how about reviewing fire outbreak countermeasures at your residence again this season? In this article, we are explaining relative countermeasures and the room after fire outbreak twice separately, this time and next time.
Fire outbreak cause and countermeasures
As for the factor, as we already stated as above, drying of the air is being considered to be the utmost cause.
As for air, if the temperature is the higher, containable moisture amount becomes the more. While temperature is the lower, containable moisture amount becomes less. Therefore, during winter when temperature is relatively low, the air becomes very dry.
In addition, even if warming up dry air from originally low temperature by using heating appliances, moisture amount contained in the air does not change, so it still remains dry..
As for the factor of fire outbreak,
The biggest factor is cigarette, the followings are setting fire consciously, cooking stove, bonfire. There are various causes, aren’t there? Among these, we are especially explaining things to be noted and countermeasures of matters to be noted at your residence.
At first, in order to prevent cigarette fire outbreak, let us thoroughly check「Smoking cigarette only at safe and designated places」「Never smoke when sleeping」「Check again before going out or before going to bed」！
Especially in winter causing fire outbreak, we can point out heating appliance of stove and others.
What we should especially be cautious is fire outbreak caused by 「electric heater」. Compared with kerosene stove, the impression seems to be safe as it does not use fire for heating. However, according to the survey of Tokyo metropolitan Fire and Disaster Management Agency, in reality, the fact is that 70% or more than 70% of fire outbreak is caused by kerosene stove fire.
The best countermeasure is 「Do not put easy to burn things close to or around kerosene stove」. Furthermore, even if you are careful, by some chance, there is a possibility that cloth or easy to burn things happen to touch, or fall down near kerosene stove. So, let us be sure to definitely put out fire before going out or sleeping and the like, if you take your eyes off for long time.
Then, that is all for today.
On 『Your personal residence・office renewal・shop or store renovation』and its interior decoration work・restoration work and so on, if you are in trouble or worried, please feel free to give us your inquiry in the first place.
We are waiting for your follow up of our Instagram, Twitter, and Facebook.
From price offer to construction finishing decoration work, our company is directly managing by ourselves, so we are supplying more reasonable and high quality and good products to you.
～～～～～～～～～～～～～～～～～～～～～～Ikebukuro～～～～～～～～～～～～～～～～～～～～～～
★If you look for interior finishing company in Ikebukuro, ask Office restoration Dot.Com★
★If you also look for office restoration work in Tokyo, ask Office restoration Dot.Com.★
Our address: 〒171-0014 4th floor, Musashiya No.3 Building, 62-10, 2-chome, Ikebukuro, Toshima, Tokyo
Free phone: 0120-978-226
～～～～～～～～～～～～～～～～～INTERIOR FINISHING COMPANY～～～～～～～～～～～～～～～～～
Hello！We are Office restoration Dot.Com. website.
We are doing decorative finishing construction work of 『Interior decorative work』『Restoration work』and the like, mainly at Ikebukuro area, Tokyo, the midpoint and also in all over Kanto area, for you.
Before opening shop or store, or office, an important work so-called「interior decorative finishing work」 shall be carried out. Literally, it is 「a work for finishing building interior decoration」. We think that many of you may not understand well what kind of interior decoration the actual object is in details.
Today, we are thinking of explaining description of work on the「interior decorative finishing work」 in detail.
What is Interior decorative finishing work industry?
It is a kind of construction industry carrying out decorative finishing work in the buildings using wood material, gypsum board, sound absorbing board, wall paper(cloth), tatami(=straw floor mat), vinyl floor tile, carpet, fusuma(=sliding paper door), and so on.
We can point out work examples as interior work, ceiling finishing work, wall sticking work, interior decoration partition work, floor finishing work, tatami work, fusuma work, furniture work, sound insulation work.
In addition, as interior decorative work, facility work of electricity・gas・water supply・air-conditioning and so on may be included.
Timing of interior decorative finishing work
Interior decorative finishing work may start around when proceeding exterior decorative finishing work, and anxiety of rain water flooding has gone.
For this reason, when constructing tower building and the like, even if exterior decorative work is still carried out at rather upper floors, there may be a possibility of already setting about interior decorative finishing work starting from rather lower floors where exterior decoration work has already finished earlier.
Details of interior decorative finishing work
We think of going to explain a few detailed works of interior decorative finishing work which we already introduced briefly above.
Wall sticking on work
It is a kind of work to go on sticking cloth or tile and others on wall bedding.
Depending on the kind of bedding, work method may vary. In general, similar to finishing at ceiling, direct sticking work method is usual.
If space of mounting heat insulating material or so is necessary, we use horizontal material to mount on wall bedding.
Ceiling finishing work
At the ceiling, there are two kinds of ceiling materials, which are ceiling bedding material and ceiling finishing material. According to the place for usage, such as personal residence, building, office and so on, it is going to be varied.
In general, as for ceiling finishing work, we go on directly sticking gypsum board, then carry on work by finishing on light steel or wooden structured ceiling bedding.
By painting, sticking cloth, sticking on panel and decorative board and so on, we use the materials to match the site, then complete interior decoration.
In order to tolerate the weight of gypsum board, we go on firmly stretching around the mounting of wooden bedding, then strengthen its structure.
The process from wall or ceiling bedding to finishing is as follows:
Marking
Wall bedding
Ceiling bedding
Ceiling finishing
Wall finishing
Floor finishing
Others
By marking work, we mark base line, then we go on mounting bedding(=light gauge steel) to stick on gypsum board at wall or ceiling.
Interior partition work
It is, a kind of work to install partition wall at shop or store room. For partition of shop or store, or office, most popular and highly sound insulating property steel partition or highly cost performance LGS(=light gauge steel) regular wall is normally used.
Floor finishing work
It is a work of sticking on floor finishing materials such as flooring, cushion floor, carpet, tile and so on. For floor finishing work, there are two kinds of work method of 「floor joist work method」 and 「direct sticking work method」, the former is mounting floor joist and isolating floor surface from bedding, while the latter is directly sticking floor finishing material.
As for detached house, floor joist work method is more often used, while direct sticking work method is mainly adopted for shop or store, or office.
Sound insulating work
In the case of studio and the like, considering neighborhood houses and shop or store, sound insulation work may be necessary to carry out. For sound insulating work, checking noise level nearby shop or store first, then carrying out setting countermeasure target value based on nearby control standards. Construction work contractor shall show countermeasure plan based on countermeasure target value and work plan. Soon after the requesting customer agrees on them, the construction work will start.
Summery
Construction work contractors which carry out interior decoration finishing work ought to have already obtained authorized general construction industry license. Full-time technical staffs who have relative Japanese national qualification are on the register.
That is all for today.
On 『Office renewal・shop or store renovation』 interior finishing decoration work・restoration work and so on, if you are in trouble or worried, please feel free to give us your inquiry in the first place.
We are waiting for your follow up of our Instagram, Twitter, and Facebook.
From price offer to construction finishing decoration work, our company is directly managing by ourselves, so we are supplying more reasonable and high quality and good products to you.
～～～～～～～～～～～～～～～～～～～～～～Ikebukuro～～～～～～～～～～～～～～～～～～～～～～
★If you look for interior finishing company in Ikebukuro, ask Office restoration Dot.Com★
★If you also look for office restoration work in Tokyo, ask Office restoration Dot.Com.★
Our address: 〒171-0014 4th floor, Musashiya No.3 Building, 62-10, 2-chome, Ikebukuro, Toshima, Tokyo
Free phone: 0120-978-226
～～～～～～～～～～～～～～～～～INTERIOR FINISHING COMPANY～～～～～～～～～～～～～～～～～
Hello！We are Office restoration Dot.Com. website.
We are doing construction finishing work of 「Interior finishing work」「Interior restoration work」mainly at Ikebukuro area, and also in all over Kanto area, for you.
This time, wear explaining，
Difference between gypsum board and calcium silicate board.
Picked up from the following total index:
1 Difference between gypsum board and calcium silicate board
1.1 Gypsum board
1.2 Calcium silicate board
1.3 Difference between gypsum board and calcium silicate board
Gypsum board
石膏ボード施工中の様子
Situation under gypsum board construction work.
As the name itself describes, it is made of gypsum as its raw material. On its core material, base-sheet(paper) is absorbed and attached to gypsum. It mainly excels fire resistant property. When gypsum board touches fire or heat, gypsum is slowly evaporated and becomes steam. There is a property of keeping the same temperature until complete emission.
This is a reason for excelling in fire resistant property.
As for gypsum board, we already explained before. If you would like it, kindly refer to that.
Calcium silicate board
化粧ケイカル板施工の様子
Situation of calcium silicate decorative board construction work.
The official name is,
Calcium silicate board.
As the name itself describes, it is made of calcium silicate as its raw material. In details, it is made of siliceous raw material, hydrated lime, pulp and others. It is made by crystallization with high temperature・high pressure.
Therefore, it excels in bending strength and water resisting property. There is little crook and shrink with moisture. So, it is often used for construction work at kitchen and toilet in areas often using water.
However, as calcium silicate board itself does not have enough water resisting property against rain and wind, it seems that「calcium silicate decorative board」painted high performance plastic paint or durable sheet sticked with better strength and appearance seems to be used often.
As variation of calcium silicate decorative board is abundant depending on manufacturers, it is used for various places such as general residence・food and drinking place・dealing in medicine company and the like.
We do not further refer in detail here.
Difference between gypsum board and calcium silicate board
Either is standard as interior finishing material. What in the world is different?
The differences besides materials are as follows:
・Calcium silicate board is better on water resisting property.
・Gypsum board is better on cost phase.
・Calcium silicate board is better on bend resistance(≒harder), but when using thinner one, calcium silicate board is more easy to be broken.
Above can be pointed out,
Including restoration construction work and the like, if you are considering interior finishing work, kindly let us know your image of 「want to make the atmosphere like this picture」「want to use as〇〇」or the like.
We will surely supply our service according to your request.
That is all for this time.
-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-=-
Surely including repair work, painting work at ceiling or wall, your new opening of shop or store, renewal, please be sure to take counsel to Office Dot Com website light heartedly.
We are waiting for your follow up of Instagram, Twitter, and Facebook.
From price offer to construction work finishing, our company is directly managing by ourselves, so we are supplying more reasonable and high quality and good products to you.
Of course, we do not mind at all if you compare our quotation with others.
「Which company should I ask for construction work? How much is approximate cost?」and so on. Also besides all above, we are waiting for your relative questions.
『Moving of your office, shop or store, warehouse』, restoration work, reform work(interior finishing decorative work), and so on.
In the first place, please give us relative inquiry.
～～～～～～～～～～～～～～～～～～～～～～Ikebukuro～～～～～～～～～～～～～～～～～～～～～～
★If you look for interior finishing company in Ikebukuro, ask Office restoration Dot.Com★
★If you also look for office restoration work in Tokyo, ask Office restoration Dot.Com.★
Our address: 〒171-0014 4th floor, Musashiya No.3 Building, 62-10, 2-chome, Ikebukuro, Toshima, Tokyo
Free phone: 0120-978-226
～～～～～～～～～～～～～～～～～INTERIOR FINISHING COMPANY～～～～～～～～～～～～～～～～～
